enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   1. Valve plate with gasket 2. Inlet from basin overflow 3. Sealing rim 4. Screw for height adjustment 5. Ball joint 6. Actuator arm 7. Joint 8. Control arm . Some modern plugholes dispense with the need for a separate plug, having instead a built-in 'pop-up plug' operated by a handle on the sink, that can move up or down to open or close the ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Non-return or check valves allow the free flow of a fluid in one direction but prevent its flow in a reverse direction. They are often seen in drainage or sewage systems but may also be used in pressurized systems. Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve ...

4. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   Foot valve: a check valve on the foot of a suction line to prevent backflow; Four-way valve: was used to control the flow of steam to the cylinder of early double-acting steam engines; Freeze seal or Freeze plug: in which freezing and melting the fluid creates and removes a plug of frozen material acting as the valve

5. Separator (oil production) - Wikipedia

   en.wikipedia.org/wiki/Separator_(oil_production)

   The valves required for oil and gas separators are oil discharge control valve, water-discharge control valve (three-phase operation), drain valves, block valves, pressure relief valves, and emergency shutdown valves (ESD). ESD valves typically stay in open position for months or years awaiting a command signal to operate.

6. Volkswagen 01M transmission - Wikipedia

   en.wikipedia.org/wiki/Volkswagen_01M_transmission

   The transmission fluid is checked from underneath the vehicle while running and the transmission in park. This must be completed before the transmission fully warms up (35-38°C). Once running, the drain plug on the bottom of the transmission oil pan is removed with a 5mm allen wrench. Some fluid will drip out whether oil level is full or low.

7. Valve actuator - Wikipedia

   en.wikipedia.org/wiki/Valve_actuator

   A typical representative of the valves to be automated is a plug-type control valve. Just like the plug in the bathtub is pressed into the drain, the plug is pressed into the plug seat by a stroke movement. The pressure of the medium acts upon the plug while the thrust unit has to provide the same amount of thrust to be able to hold and move ...