Search results
Results from the WOW.Com Content Network
As an example, assume the case of Wake-on-LAN. Traditionally, the OS controls Wake-on-LAN and must call third-party device drivers to enable support on a network card. With the HECI bus, the host is able to assert its request line (REQ#), the ME will assert its grant line (GNT#), and the host can send its message using its serial transmit signal.
In the mid-1990s, a facility for supplying new microcode was initially referred to as the Pentium Pro BIOS Update Feature. [18] [19] It was intended that user-mode applications should make a BIOS interrupt call to supply a new "BIOS Update Data Block", which the BIOS would partially validate and save to nonvolatile BIOS memory; this could be supplied to the installed processors on next boot.
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
A general protection fault (GPF) in the x86 instruction set architectures (ISAs) is a fault (a type of interrupt) initiated by ISA-defined protection mechanisms in response to an access violation caused by some running code, either in the kernel or a user program.
An option ROM for the PC platform (i.e. the IBM PC and derived successor computer systems) is a piece of firmware that resides in ROM on an expansion card (or stored along with the main system BIOS), which gets executed to initialize the device and (optionally) add support for the device to the BIOS.
Some BIOS implementations allow overclocking, an action in which the CPU is adjusted to a higher clock rate than its manufacturer rating for guaranteed capability. Overclocking may, however, seriously compromise system reliability in insufficiently cooled computers and generally shorten component lifespan.
As the drive is not redundant, reporting segments as failed will only increase manual intervention. Without a hardware RAID controller or a software RAID implementation to drop the disk, normal (no TLER) recovery ability is most stable. In a software RAID configuration whether or not TLER is helpful is dependent on the operating system.
On some systems, a computer user can trigger an NMI through hardware and software debugging interfaces and system reset buttons. Programmers typically use debugging NMIs to diagnose and fix faulty code. In such cases, an NMI can execute an interrupt handler that transfers control to a special monitor program. From this program, a developer can ...