Search results
Results from the WOW.Com Content Network
LogoFAIL is a security vulnerability and exploit thereof that affects computer motherboard firmware with TianoCore EDK II, including Insyde Software's InsydeH2O modules and similar code in AMI and Phoenix firmware, which are commonly found on both Intel and AMD motherboards, and which enable loading of custom boot logos.
Typical POST screen (AMI BIOS) Summary screen after POST and before booting an operating system (AMI BIOS) A power-on self-test ( POST ) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.
This is because CMOS may experience a failure mode known as a stuck-open fault, which cannot be reliably detected with one test vector and requires that two vectors be applied sequentially. The model also fails to detect bridging faults between adjacent signal lines, occurring in pins that drive bus connections and array structures.
DragonFly BSD, DOS, FreeBSD, kFreeBSD, Linux, macOS, NetBSD, OpenBSD, Solaris, Windows ... It can be used to flash firmware images such as BIOS or coreboot, or to ...
coreboot, formerly known as LinuxBIOS, [5] is a software project aimed at replacing proprietary firmware (BIOS or UEFI) found in most computers with a lightweight firmware designed to perform only the minimum number of tasks necessary to load and run a modern 32-bit or 64-bit operating system.
It also contains a command-line interface, which makes it easier to fix or modify GRUB if it is misconfigured or corrupt. [16] Loadlin is a bootloader that can replace a running DOS or Windows 9x kernel with the Linux kernel at run time. This can be useful in the case of hardware that needs to be switched on via software and for which such ...
AntiCMOS is a boot virus.Its first discovery was at Lenart, Slovenia, which led to its alias of Lenart.It was isolated in Hong Kong several times at the beginning of 1994, but did not become common until it spread to North America in the Spring of 1995.
Race condition in a logic circuit. Here, ∆t 1 and ∆t 2 represent the propagation delays of the logic elements. When the input value A changes from low to high, the circuit outputs a short spike of duration (∆t 1 + ∆t 2) − ∆t 2 = ∆t 1.