enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Static pressure - Wikipedia

    en.wikipedia.org/wiki/Static_pressure

    The term (hydro)static pressure is sometimes used in fluid statics to refer to the pressure of a fluid at a nominated depth in the fluid. In fluid statics the fluid is stationary everywhere and the concepts of dynamic pressure and total pressure are not applicable.

  3. Pressure head - Wikipedia

    en.wikipedia.org/wiki/Pressure_head

    This is why static pressure and dynamic pressure are never the same in a system in which the fluid is in motion. This pressure difference arises from a change in fluid velocity that produces velocity head, which is a term of the Bernoulli equation that is zero when there is no bulk motion of the fluid. In the picture on the right, the pressure ...

  4. Hydraulic head - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_head

    On Earth, additional height of fresh water adds a static pressure of about 9.8 kPa per meter (0.098 bar/m) or 0.433 psi per foot of water column height. The static head of a pump is the maximum height (pressure) it can deliver. The capability of the pump at a certain RPM can be read from its Q-H curve (flow vs. height).

  5. Pressure coefficient - Wikipedia

    en.wikipedia.org/wiki/Pressure_coefficient

    is the static pressure at the point at which pressure coefficient is being evaluated is the static pressure in the freestream (i.e. remote from any disturbance) is the freestream fluid density (Air at sea level and 15 °C is 1.225 /)

  6. Total dynamic head - Wikipedia

    en.wikipedia.org/wiki/Total_dynamic_head

    In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.

  7. Pressure - Wikipedia

    en.wikipedia.org/wiki/Pressure

    The average water pressure acting against a dam depends on the average depth of the water and not on the volume of water held back. For example, a wide but shallow lake with a depth of 3 m (10 ft) exerts only half the average pressure that a small 6 m (20 ft) deep pond does.

  8. Young–Laplace equation - Wikipedia

    en.wikipedia.org/wiki/Young–Laplace_equation

    In physics, the Young–Laplace equation (/ l ə ˈ p l ɑː s /) is an algebraic equation that describes the capillary pressure difference sustained across the interface between two static fluids, such as water and air, due to the phenomenon of surface tension or wall tension, although use of the latter is only applicable if assuming that the wall is very thin.

  9. Hydrostatics - Wikipedia

    en.wikipedia.org/wiki/Hydrostatics

    In medicine, hydrostatic pressure in blood vessels is the pressure of the blood against the wall. It is the opposing force to oncotic pressure . In capillaries, hydrostatic pressure (also known as capillary blood pressure) is higher than the opposing “colloid osmotic pressure” in blood—a “constant” pressure primarily produced by ...