Search results
Results from the WOW.Com Content Network
Rate-of-Rise (ROR) heat detectors operate on a rapid rise in element temperature of 6.7 to 8.3°C (12.1 to 14.9°F) increase per minute, irrespective of the starting temperature. This type of heat detector can operate at a lower temperature fire condition than would be possible if the threshold were fixed.
A fire alarm control panel Fire alarm speaker and pull station. Fire alarm systems are composed of several distinct parts: Fire alarm control panel (FACP), or fire alarm control unit (FACU): This component, the hub of the system, monitors inputs and system integrity, controls outputs, and transmits information.
Linear heat detection (LHD) (also known as linear detection wire or linear heat detection cable or linear heat) is a very commonly used method of fire detection. It can detect a fire anywhere along the length of the cable, and can be of lengths in excess of a kilometer. Applications can range from building fire alarm systems to mobile plant ...
A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection.Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system.
A fire alarm control panel (FACP), fire alarm control unit (FACU), fire indicator panel (FIP), or simply fire alarm panel is the controlling component of a fire alarm system. The panel receives information from devices designed to detect and report fires, monitors their operational integrity, and provides for automatic control of equipment, and ...
The SpectrAlert series included horn strobes, strobes, remote horns, chimes, chime strobes, speakers, and speaker strobes. A main feature of these alarms was the ability to sync them using a System Sensor MDL sync module or the System Sensor sync protocol on a supported fire alarm control panel. Three years after the initial release of the ...
The fire detection and fire alarm system subcommittee of ISO/TC 21, Equipment for Fire Protection and Fire Fighting, had oversight for development of five standards covering detectors, control and indicating equipment. ISO 7240-2:3003 specifies requirements, test methods and performance criteria for control and indicating equipment (c.i.e.) for ...
[4] [5] In general, however, automatic fire suppression systems fall into two categories: engineered and pre-engineered systems. [6] Engineered fire suppression systems are design specific and most commonly used for larger installations where the system is designed for a particular application. Examples include large marine and land vehicle ...