Search results
Results from the WOW.Com Content Network
Types used in commercial and industrial low-voltage distribution systems are rated to safely interrupt 200,000 amperes. The rating of power circuit breakers varies according to the application voltage; a circuit breaker that interrupts 50,000 amperes at 208 volts might be rated to interrupt only 10,000 amperes at 600 volts, for example.
The motor size constant and motor velocity constant (, alternatively called the back EMF constant) are values used to describe characteristics of electrical motors. Motor constant [ edit ]
Brake horsepower per cubic centimeter or (bhp/cc) is a figure of merit that is used to indicate the 'state of tune' of an internal combustion engine. It is defined as the ratio of the engine's net power output to its displacement, the internal size. Power is measured at its rated speed and full throttle.
For example, a 100 HP, 460 V, 60 Hz, 1775 RPM (4-pole) induction motor supplied with 460 V, 75 Hz (6.134 V/Hz), would be limited to 60/75 = 80% torque at 125% speed (2218.75 RPM) = 100% power. [26] At higher speeds, the induction motor torque has to be limited further due to the lowering of the breakaway torque [ a ] of the motor.
Contact load in amperes for heaters (AC1) and motors (AC3) can be found directly on the contactor. The "Utilization category" are mainly categorized in IEC 60947 in the following volume: Volume 1: General requirements; Volume 2: Circuit-breakers; Volume 3: Circuit-breakers, circuit-breakers, switch-disconnectors and switch-fuse units
NEMA size Max. continuous amperes Max. HP at 200 ... Motor starter; References This page was last edited on 20 June 2020, at 20:42 (UTC ...
Engine power is the power that an engine can put out. It can be expressed in power units, most commonly kilowatt, pferdestärke (metric horsepower), or horsepower.In terms of internal combustion engines, the engine power usually describes the rated power, which is a power output that the engine can maintain over a long period of time according to a certain testing method, for example ISO 1585.
Denoted by the cylinder block painted red, the engine made its debut in the Holden EH in capacities of 149 cubic inches (2,447 cc) and 179 cubic inches (2,930 cc) (or HP) producing 100 and 115 brake horsepower (75 and 86 kW) respectively. This was a power increase of 33 per cent and 53 per cent over the grey motor.