Search results
Results from the WOW.Com Content Network
A notch weir is any weir where the physical barrier is significantly higher than the water level except for a specific notch (often V-shaped) cut into the panel. At times of normal flow all the water must pass through the notch, simplifying flow volume calculations, and at times of flood the water level can rise and submerge the weir without ...
The waste weir also functioned as an opening to drain the entire canal prism of water for repairs, or for winter (to avoid damage from freezing water), or in anticipation of flooding. [3] [4] Morris Canal Overflow and Waste Weir site. In some cases when a creek was used to feed the canal, a waste weir was necessary for excess water from the creek.
An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...
As part of an irrigation system, a number of sluices at the deeper bund area allows water to be fed into surface canals which distribute water to crops within the tank command area. [8] A surplus/waste weir or the overflow outlet allows water to drain into a downstream tank. [8] The bund or embankment is an uneven bow or crescent-shaped ...
Weir on Lake Tecumseh, Virginia. A flow control structure is a device that alters the flow of water in a stream, drainage channel or pipe. As a group these are passive structures since they operate without intervention under different amounts of water flow and their impact changes based on the quantity of water available.
A weir (sometimes called an "overflow dam") is a small dam that is often used in a river channel to create an impoundment lake for water abstraction purposes. It can also be used for flow measurement or retardation.
In hydraulic engineering, a nappe is a sheet or curtain of water that flows over a weir or dam. The upper and lower water surface have well-defined characteristics that are created by the crest of a dam or weir. [1] Both structures have different features that characterize how a nappe might flow through or over impervious concrete structures. [2]
They raise 200,000 litres of water per hour (52,800 US gallons). [10] The wheel takes one minute to complete a revolution, much longer than smaller norias. [10] To drive a wheel bearing such a weight of water, an extraordinarily long weir at a very acute angle was built to concentrate the power of the river on the base of the wheel.