Search results
Results from the WOW.Com Content Network
In an ejector, a working fluid (liquid or gaseous) flows through a jet nozzle into a tube that first narrows and then expands in cross-sectional area. The fluid leaving the jet is flowing at a high velocity which due to Bernoulli's principle results in it having low pressure, thus generating a vacuum. The outer tube then narrows into a mixing ...
Direct impingement operation increases the amount of heat that is deposited in the receiver while firing, which can burn off and cover up lubricants. The bolt, extractor, ejector, pins, and springs are also heated by the same high-temperature gas. These combined factors reduce service life of these parts, reliability, and mean time between ...
A practical difference between dynamic and positive-displacement pumps is how they operate under closed valve conditions. Positive-displacement pumps physically displace fluid, so closing a valve downstream of a positive-displacement pump produces a continual pressure build up that can cause mechanical failure of pipeline or pump.
Figure 1 - Venturi scrubber Ejector venturi scrubber. A venturi scrubber is designed to effectively use the energy from a high-velocity inlet gas stream to atomize the liquid being used to scrub the gas stream. This type of technology is a part of the group of air pollution controls collectively referred to as wet scrubbers.
This fluid specification change provided better oxidation control, anti-wear performance, and higher static capacity capabilities were also included. Oxidation control of the fluid was measured by a new Merc-O-Matic oxidation test. This fluid was first used in the following transmissions: 1964 C-4 3-Speed automatic transmission
A centrifugal extractor—also known as a centrifugal contactor or annular centrifugal contactor—uses the rotation of the rotor inside a centrifuge to mix two immiscible liquids outside the rotor and to separate the liquids in the field of gravity inside the rotor.
Test separators can be vertical, horizontal, or spherical. They can be two-phase or three-phase. They can be permanently installed or portable (skid or trailer mounted). Test separators can be equipped with various types of meters for measuring the oil, gas, and/or water for potential tests, periodic production tests, marginal well tests, etc.
For a steam ejector, the motive fluid is steam. For water-cooled surface condensers, the shell's internal vacuum is most commonly supplied by and maintained by an external steam jet ejector system. Such an ejector system uses steam as the motive fluid to remove any non-condensible gases that may be present in the surface condenser.