Ads
related to: marine camshaft overlap unit replacement
Search results
Results from the WOW.Com Content Network
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.
A camshaft operating two valves. A camshaft is a shaft that contains a row of pointed cams in order to convert rotational motion to reciprocating motion.Camshafts are used in piston engines (to operate the intake and exhaust valves), [1] [2] mechanically controlled ignition systems and early electric motor speed controllers.
With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in drawing in the fresh charge.
Introduced by BL in 1978 in the rear wheel drive Series 3 Morris Marina and the smaller engined versions of the front-wheel-drive Princess, it was intended to replace the 1.8 L B-series unit. The main advance over the B series was that the new unit was of belt driven overhead camshaft configuration, with an aluminium cylinder head.
Camshafts; Connecting rods (rotating around the piston end as required by the varying horizontal offset between the piston and the crank throw) The imbalances can be caused by either the static mass of individual components or the cylinder layout of the engine, as detailed in the following sections.
The absence of a camshaft also means that the parasitic load on the engine is lower, which is particularly useful in large marine engines, as it can equate to a large amount of power savings. With a camless engine, fuel injection and exhaust timing are directly controlled by an engine control unit and can be constantly changed and adjusted ...
The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s and compared to timing chains are less expensive, smaller, lighter, quieter ...
The ratio is determined by the ratio of the distances from the rocker arm's pivot point to the point where it touches the valve and the point where it touches the pushrod/camshaft. A rocker ratio greater than one essentially increases the camshaft's lift. Current automotive design favors rocker arm ratios of about 1.5:1 to 1.8:1.
Ads
related to: marine camshaft overlap unit replacement