Search results
Results from the WOW.Com Content Network
A number of different units (some only of historical interest) are shown and expressed in terms of the corresponding SI unit. Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
Section 3.8 introduces atomic units and gives a table of atomic units of various physical quantities and the conversion factor to the SI units. Section 7.3(v) gives a concise but clear tutorial on practical use of atomic units, in particular how to understand equations "written in atomic units".
In physics, natural unit systems are measurement systems for which selected physical constants have been set to 1 through nondimensionalization of physical units.For example, the speed of light c may be set to 1, and it may then be omitted, equating mass and energy directly E = m rather than using c as a conversion factor in the typical mass–energy equivalence equation E = mc 2.
Listed below are all conversion factors that are useful to convert between all combinations of the SI base units, and if not possible, between them and their unique elements, because ampere is a dimensionless ratio of two lengths such as [C/s], and candela (1/683 [W/sr]) is a dimensionless ratio of two dimensionless ratios such as ratio of two volumes [kg⋅m 2 /s 3] = [W] and ratio of two ...
The conversion procedure for some units (for example, the Mach unit of speed) are built into Module:Convert as they are too complex to be specified in a table. That is indicated by entering a code (which must be the same as used in the module) in the Extra column.
The table usually lists only one name and symbol that is most commonly used. The final column lists some special properties that some of the quantities have, such as their scaling behavior (i.e. whether the quantity is intensive or extensive ), their transformation properties (i.e. whether the quantity is a scalar , vector , matrix or tensor ...
The conversion procedure for some units (for example, the Mach unit of speed) are built into Module:Convert as they are too complex to be specified in a table. That is indicated by entering a code (which must be the same as used in the module) in the Extra column.