Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .
This axle is referred to as a Dana 44 ICA or Dana 44 IRS. All 1980–1982 Chevrolet Corvette C3 and manual transmission equipped 1985–1996 Chevrolet Corvette C4 had this axle. The 2005–06 Pontiac GTO, The Dodge Viper has always used a Dana 44 IRS setup. The majority of Corvette and Viper Dana 44 IRS set ups use a limited slip differential.
The ID number C300-15 is stamped on the case. The output for the front drive shaft is on the right side and the rear output in line with the input. Low range is 2.62:1. One common modification of the Dana 300 is to add oil paddles to the main shaft to prevent oil starvation of the rear bearing. The Dana 300 was used in Jeep CJs from 1980 to 1986.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
In 1993 Jeep re-introduced Quadra-Trac, this time on the Jeep Grand Cherokee using the NP249 transfer case. Like the NP219, this transfer case utilizes a center differential with a viscous coupler to provide smooth and efficient four-wheel drive operation on all surfaces. This system has 4WD All-Time, Neutral, and 4WD Low modes.