enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port. Because there are two separate controllers in each USB 3.0 host, USB 3.0 devices transmit and receive at USB 3.0 signaling rates regardless of USB 2.0 ...

3. USB hub - Wikipedia

   en.wikipedia.org/wiki/USB_hub

   To allow high-speed (USB 2.0) devices to operate in their fastest mode, all hubs between the devices and the computer must be high-speed. High-speed devices should fall back to full-speed (USB 1.1) when plugged into a full-speed hub (or connected to an older full-speed computer port). While high-speed hubs can communicate at all device speeds ...

4. USB communications - Wikipedia

   en.wikipedia.org/wiki/USB_communications

   All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x.

5. Extensible Host Controller Interface - Wikipedia

   en.wikipedia.org/wiki/Extensible_Host_Controller...

   The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.

6. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...

7. Direct cable connection - Wikipedia

   en.wikipedia.org/wiki/Direct_cable_connection

   There are at least 2 known USB-crossover cables capable of bidirectional data-transfer between computers similar to RJ45/Ethernet cables: ProlificUSA.com's TE-C0372 High Speed USB 2.0 Host to Host Bridge Cable (PL25A1 Chipset) and ProlificUSA.com's TE-C0363 Superspeed USB 3.0 Host to Host Bridge Cable (PL27A1 Chipset), and drivers for these ...