enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Multi-mode optical fiber - Wikipedia

   en.wikipedia.org/wiki/Multi-mode_optical_fiber

   The equipment used for communications over multi-mode optical fiber is less expensive than that for single-mode optical fiber. [1] Typical transmission speed and distance limits are 100 Mbit/s for distances up to 2 km (), 1 Gbit/s up to 1000 m, and 10 Gbit/s up to 550 m.

3. Fiber cable termination - Wikipedia

   en.wikipedia.org/wiki/Fiber_cable_termination

   A fiber pigtail is a single, short, usually tight-buffered, optical fiber that has an optical connector pre-installed on one end and a length of exposed fiber at the other end. The end of the pigtail is stripped and fusion spliced to a single fiber of a multi-fiber trunk. Splicing of pigtails to each fiber in the trunk "breaks out" the multi ...

4. Line splice - Wikipedia

   en.wikipedia.org/wiki/Line_splice

   Fiber optic cable sleeve Fiber optic cable splicer. Fiber-optic cables are spliced using a special arc-splicer, with installation cables connected at their ends to respective "pigtails" - short individual fibers with fiber-optic connectors at one end. The splicer precisely adjusts the light-guiding cores of the two ends of the glass fibers to ...

5. G.651.1 - Wikipedia

   en.wikipedia.org/wiki/G.651.1

   The G.651.1 Recommendation builds on a previous fiber optic specification in G.651. G.651.1 was first published in 2007. Revisions of the standard were since published in 2008, and 2018 (November).

6. Optical fiber - Wikipedia

   en.wikipedia.org/wiki/Optical_fiber

   Extrinsic fiber optic sensors use an optical fiber cable, normally a multi-mode one, to transmit modulated light from either a non-fiber optical sensor—or an electronic sensor connected to an optical transmitter. A major benefit of extrinsic sensors is their ability to reach otherwise inaccessible places.

7. Optical fiber connector - Wikipedia

   en.wikipedia.org/wiki/Optical_fiber_connector

   Optical fiber connectors are used in telephone exchanges, for customer premises wiring, and in outside plant applications to connect equipment and fiber-optic cables, or to cross-connect cables. Most optical fiber connectors are spring-loaded, so the fiber faces are pressed together when the connectors are mated.