enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Banjo fitting - Wikipedia

   en.wikipedia.org/wiki/Banjo_fitting

   Two banjo fittings (upper center of photo) atop automotive brake calipers. The copper crush washer in the gap between the fitting and body of the caliper completes the seal. Compared to pipe fittings that are themselves threaded, banjo fittings have the advantage that they do not have to be rotated relative to the host fitting. This avoids ...

3. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   A hose clamp used to hold the leather in place while tying-in the bag of bagpipes. They can also be used in a similar way, as a simple means for the transmission of small amounts of power. A short length of hose is clipped between two shafts where vibration or variations in alignment may be taken up by the flexibility of the hose. This ...

4. Air line - Wikipedia

   en.wikipedia.org/wiki/Air_line

   Two types of air line hose. Air line hoses are flexible tubes used to convey pressurised air. They are commonly used for carrying a supply of compressed air to operate pneumatic powered systems, such as a road vehicle air brake system for large vehicles and a railway air brake system for railway carriages / locomotives. [2]

5. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   The "Air King" [14] universal air hose coupling, also known as a "Chicago style" fitting, is malleable iron or brass "quarter turn" "sexless coupling" usually found on large pneumatic tools like jackhammers. [6] The fitting is considered "universal", because a common two-lug head is used on all sizes ranging from 0.25 to 1 inch (6 to 25 mm).

6. Air-line fitting - Wikipedia

   en.wikipedia.org/wiki/Air-line_fitting

   One side is connected to a flexible supply hose; the other may be attached to a manifold, valve, tool, or another hose. A female coupler is used on the supply side, and a male nipple is used on the receiving side. Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler.

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   A 37° flare type end fitting for flexible hose. The AN thread (also A-N) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.