enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).

3. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector.

4. Edge connector - Wikipedia

   en.wikipedia.org/wiki/Edge_connector

   IBM PCs used edge connector sockets attached to ribbon cables to connect 5.25" floppy disk drives. 3.5" drives use a pin connector instead. Video game cartridges typically take the form of a PCB with an edge connector: the socket is located within the console itself.

5. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   These connectors are frequently mounted at a right angle to the PCB, allowing a cable to be plugged into the edge of the PCB assembly. While angled connectors traditionally occupied significant room on the PCB, flat SMD connector variants are produced by various manufacturers.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Chassis or panel connectors permanently attached to a piece of equipment so users can connect a cable to a stationary device; PCB mount connectors soldered to a printed circuit board, providing a point for cable or wire attachment. [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily ...

7. Zero insertion force - Wikipedia

   en.wikipedia.org/wiki/Zero_insertion_force

   ZIF wire-to-board connectors are used for attaching wires to printed circuit boards inside electronic equipment. An example would be the cable between the LCD screen and motherboard in laptops. The wires, often formed into a ribbon cable, are pre-stripped and the bare ends are placed inside the connector. The two sliding parts of the connector ...