enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Micro ribbon connector - Wikipedia

   en.wikipedia.org/wiki/Micro_ribbon_connector

   The connectors are manufactured in many capacities, including 14-, 24-, 36-, 50-, 64-, and 100-pin varieties. They may be mounted on boards , panels, or may terminate cables . Wires are attached by means of solder , crimping or insulation displacement .

3. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...

4. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector. This allows two drives ...

5. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so ...

6. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   Early SCSI interfaces commonly used a 50-pin micro ribbon connector. This connector is similar to the 36-pin connector used by Centronics for the parallel interface on their printers, thus the connector became popularly known as "Centronics SCSI" or "CN-50". It is also referred to as a "SCSI-1 connector"; since many connectors have been used ...

7. Parallel ATA - Wikipedia

   en.wikipedia.org/wiki/Parallel_ATA

   Round parallel ATA cables (as opposed to ribbon cables) were eventually made available for 'case modders' for cosmetic reasons, as well as claims of improved computer cooling and were easier to handle; however, only ribbon cables are supported by the ATA specifications. Pin 20 In the ATA standard, pin 20 is defined as a mechanical key and is ...