Search results
Results from the WOW.Com Content Network
Normally a character cell has 8 scan lines, 0–7. So, CX=0607h is a normal underline cursor, CX=0007h is a full-block cursor. If bit 5 of CH is set, that often means "Hide cursor". So CX=2607h is an invisible cursor. Some video cards have 16 scan lines, 00h-0Fh. Some video cards don't use bit 5 of CH. With these, make Start>End (e.g. CX=0706h)
IRQ 9 – Advanced Configuration and Power Interface (ACPI) system control interrupt on Intel chipsets. [6] And/or left for the use of peripherals (use depends on OS) IRQ 10 – The interrupt is left for the use of peripherals (for example, SCSI or NIC) IRQ 11 – The interrupt is left for the use of peripherals (for example, SCSI or NIC)
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
The device is programmed with an address to write to (this address is generally a control register in an interrupt controller), and a 16-bit data word to identify it. The interrupt number is added to the data word to identify the interrupt. [1] Some platforms such as Windows do not use all 32 interrupts but only use up to 16 interrupts. [7]
However, if it reads "32-bit operating system, x86-based processor," the computer does not support the 64-bit version of Windows. If the device can't run the 64-bit version, consider purchasing a ...
For example, hardware timers send interrupts to the CPU at regular intervals. Most operating systems execute a HLT instruction when there is no immediate work to be done, putting the processor into an idle state. In Windows NT, for example, this instruction is run in the "System Idle Process". On x86 processors, the opcode of HLT is 0xF4.
The Interrupt flag (IF) is a flag bit in the CPU's FLAGS register, which determines whether or not the (CPU) will respond immediately to maskable hardware interrupts. [1] If the flag is set to 1 maskable interrupts are enabled. If reset (set to 0) such interrupts will be disabled until