Search results
Results from the WOW.Com Content Network
[note 1] In a flying boat hull or floatplane float, the longitudinal line of sharp change in cross-section where the bottom plane meets the sidewall is an example of a chine. On some supersonic aircraft a chine extends sideways for some distance, with a very sharp edge blending in with the main wing leading edge root.
Modern aircraft wings may have different airfoil sections along the wing span, each one optimized for the conditions in each section of the wing. Movable high-lift devices, flaps and sometimes slats, are fitted to airfoils on almost every aircraft. A trailing edge flap acts similarly to an aileron; however, it, as opposed to an aileron, can be ...
The NACA four-digit wing sections define the profile by: [2] First digit describing maximum camber as percentage of the chord. Second digit describing the distance of maximum camber from the airfoil leading edge in tenths of the chord. Last two digits describing maximum thickness of the airfoil as percent of the chord. [3]
A fixed-wing aircraft may have more than one wing plane, stacked one above another: Biplane: two wing planes of similar size, stacked one above the other. The biplane is inherently lighter and stronger than a monoplane and was the most common configuration until the 1930s. The very first Wright Flyer I was a biplane.
Years of research and experience with the unusual conditions of supersonic flow have led to some interesting conclusions about airfoil design. Considering a rectangular wing, the pressure at a point P with coordinates (x,y) on the wing is defined only by the pressure disturbances originated at points within the upstream Mach cone emanating from point P. [3] As result, the wing tips modify the ...
A flying wing is an aeroplane that has no definite fuselage or tailplane, with its crew, payload, fuel, and equipment housed inside the main wing structure. A flying wing may have various small protuberances such as pods, nacelles, blisters, booms, or vertical stabilizers. [1] A clean flying wing is sometimes presented as theoretically the most ...
Cross section of an aerodynamic surface with the trailing edge emphasised An American Aviation AA-1 Yankee being refuelled. Its wing trailing edge can be seen with aileron (deployed downwards) and flap. The trailing edge of an aerodynamic surface such as a wing is its rear edge, where the airflow separated by the leading edge meets. [1]
The wing, horizontal stabilizer, vertical stabilizer and propeller/rotor blades of an aircraft are all based on aerofoil sections, and the term chord or chord length is also used to describe their width. The chord of a wing, stabilizer and propeller is determined by measuring the distance between leading and trailing edges in the direction of ...