Search results
Results from the WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Pipe sizes can be confusing because the terminology may relate to historical dimensions. For example, a half-inch iron pipe does not have any dimension that is a half inch. Initially, a half inch pipe did have an inner diameter of 1 ⁄ 2 inch (13 mm)—but it also had thick walls. As technology improved, thinner walls became possible, but the ...
The centimetre (SI symbol: cm) is a unit of length in the metric system equal to 10 −2 metres ( 1 / 100 m = 0.01 m). To help compare different orders of magnitude, this section lists lengths between 10 −2 m and 10 −1 m (1 cm and 1 dm). 1 cm – 10 millimeters; 1 cm – 0.39 inches; 1 cm – edge of a square of area 1 cm 2
Copper tubing, however, is measured in nominal size, 1 ⁄ 8 inch less than the outside diameter. The Schedule system is used for standard pipe thicknesses. Alcohol content is frequently given in proof, 2 × percent alcohol by volume; The cord is used for volume of firewood. The square is used to mean 100 square feet in construction.
Speed square, or rafter square, or rafter angle square, or triangle square, or layout square A speed square is a triangular carpenters square combining functions of the combination square, try square, and framing square into one. It can be used to calculate and mark angles, to suspend a plumb bob, and as a fence for a circular saw. [21] [22] [23]
For example, DN20 is the size for copper pipe with an outside diameter of 19.05 mm or 3 ⁄ 4 inch. While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a ...
Iron Pipe Size (IPS or I.P.S.) pipe sizing system based on the inside diameter (ID) of pipe. It was widely used from the early 19th century to the mid 20th century and is still in use by some industries, including major PVC pipe manufacturers, as well as for some legacy drawings and equipment.
A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow.