Search results
Results from the WOW.Com Content Network
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
The Chevrolet Tahoe Z71 also exhibited a monochromatic appearance similar to the Tahoe Limited, but instead of Onyx Black, the Tahoe Z71 was offered in either Light Pewter Metallic, Victory Red, Emerald Green Metallic, or Indigo Blue Metallic. Features of the Tahoe Z71 were similar to those of the Tahoe Limited with a few key differences to ...
The result is an engine that fails to maintain idle RPM and frequently stalls. A jammed actuator may be freed simply by cleaning it. However an actuator that has stopped working due to a fault in its servomotor will need replacement. Air leaks in either the stepper housing or pipes will cause elevated idle RPM.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
graph with an example of steps in a failure mode and effects analysis. Failure mode and effects analysis (FMEA; often written with "failure modes" in plural) is the process of reviewing as many components, assemblies, and subsystems as possible to identify potential failure modes in a system and their causes and effects. For each component, the ...
An updated 4L60E, the 4L65E (RPO M32), was phased in the 2001 model year when coupled behind the 6.0 Vortec. Five-pinion front and rear planetaries, along with an additional 3/4 clutch allowing 7 clutches in the input housing and induction hardened input shaft assembly, were improved to withstand up to 380 ft⋅lb (520 N⋅m) of torque.
The power supply is from a DC or AC motor. The typical motor is a 12v DC, but other voltages are available. Actuators have a switch to reverse the polarity of the motor, which makes the actuator change its motion. The speed and force of an actuator depend on its gearbox. The amount of force depends on the actuator’s speed.
Here, small valves were attached to the original control cables, controlling the flow of oil into an associated actuator connected to the control surface. One of the earliest fittings of a hydraulic boost system was to ailerons on late-war models of the P-38L, removing the need for great human strength to achieve a higher rate of roll.