Search results
Results from the WOW.Com Content Network
The choice of construction method is a key aspect of the construction planning activity. The choice of construction method affects the extent to which construction prerequisites (e.g. Requirements analysis , Software design , .. etc.) are performed, the order in which they are performed, and the degree to which they are expected to be completed ...
Common exceptions include an invalid argument (e.g. value is outside of the domain of a function), [5] an unavailable resource (like a missing file, [6] a network drive error, [7] or out-of-memory errors [8]), or that the routine has detected a normal condition that requires special handling, e.g., attention, end of file. [9]
According to a 2008 paper by Westley Weimer and George Necula, the syntax of the try...finally blocks in Java is a contributing factor to software defects. When a method needs to handle the acquisition and release of 3–5 resources, programmers are apparently unwilling to nest enough blocks due to readability concerns, even when this would be ...
Not all defects cause a failure. For example, a defect in dead code will not be considered a failure. A defect that does not cause failure at one point in time may later occur due to environmental changes. Examples of environment change include running on new computer hardware, changes in data, and interacting with different software. [12] A ...
The average rate of cosmic-ray soft errors is inversely proportional to sunspot activity. That is, the average number of cosmic-ray soft errors decreases during the active portion of the sunspot cycle and increases during the quiet portion. This counter-intuitive result occurs for two reasons.
The emphasis on applying a broad spectrum of defect prevention and defect detection practices is based on the premise that different development testing techniques are tuned to expose different types of defects at different points in the software development lifecycle, so applying multiple techniques in concert decreases the risk of defects ...
The software development process is a typical application of Fagan inspection. As the costs to remedy a defect are up to 10 to 100 times less in the early operations compared to fixing a defect in the maintenance phase, [1] it is essential to find defects as close to the point of insertion as possible.
In addition to or instead of defect, some use: error, flaw or fault. Engineered systems is a broad classification encompassing but not limited to: software, computer hardware, electronics, circuitry and machinery. The undesirable result can be classified and described many ways including: intermittent, transient, glitch, crash or hang.