Search results
Results from the WOW.Com Content Network
This UART has 16-byte FIFO buffers. Its receive interrupt trigger levels can be set to 1, 4, 8, or 14 characters. Its maximum standard serial port speed if the operating system has a 1 millisecond interrupt latency is 128 kbit/s. Systems with lower interrupt latencies or with DMA controllers could handle higher baud rates.
A universal synchronous and asynchronous receiver-transmitter (USART, programmable communications interface or PCI) [1] is a type of a serial interface device that can be programmed to communicate asynchronously or synchronously. See universal asynchronous receiver-transmitter (UART) for a discussion of the asynchronous capabilities of these ...
Byte-oriented framing protocol is "a communications protocol in which full bytes are used as control codes. Also known as character-oriented protocol." [1] For example UART communication is byte-oriented. The term "character-oriented" is deprecated, [by whom?] since the notion of character has changed. An ASCII character fits to one byte (octet ...
The 8250 UART was used in several 8-bit computers at least since 1978. IBM used the 8250 UART in the IBM PC (1981). The 8250A and 8250B revisions were later released, and the 16450 was introduced with the IBM Personal Computer/AT (1984). The main difference between releases was the maximum communication speed. [4]
For example, the UART-based FlexWire protocol begins each frame with a 'U' (0x55) sync byte. FlexWire receivers use the sync byte to precisely set their UART bit-clock frequency without a high-precision oscillator. [4] For example, the Ethernet preamble contains 56 bits of alternating 1 and 0 bits for synchronizing bit clocks.
Bidirectional communication with two unidirectional lines; Point-to-point or multi-slave networks; Maximum user data rate, transmission data depending on driver and line of e.g. RS-422: 10 MHz, 1 km; LVDS: 100 Mbit/s; Independent of the applied physical layer; CRC secured communication (sensor data and control data secured separately) [8]
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
Parity was also used on at least some paper-tape (punched tape) data entry systems (which preceded magnetic-tape systems). On the systems sold by British company ICL (formerly ICT) the 1-inch-wide (25 mm) paper tape had 8 hole positions running across it, with the 8th being for parity. 7 positions were used for the data, e.g., 7-bit ASCII.