Search results
Results from the WOW.Com Content Network
Dip soldering is a small-scale soldering process by which electronic components are soldered to a printed circuit board (PCB) to form an electronic assembly. The solder wets to the exposed metallic areas of the board (those not protected with solder mask ), creating a mechanical and electrical connection.
Reballing involves dismantling, heating the chip until it can be removed from the board, typically with a hot-air gun and vacuum pickup tool, removing the device, removing solder remaining on the device and board, putting new solder balls in place, replacing the original device if there was a poor connection, or using a new one, and heating the ...
Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...
Wave soldering uses surface tension to keep solder from bridging the insulating gaps between the copper lines of flux-coated printed wiring boards/printed circuit boards. The electric soldering iron is widely used for hand-soldering, consisting of a heating element in contact with the "iron" (a larger mass of metal, usually copper) which is in ...
Printed circuit board manufacturing is the process of manufacturing bare printed circuit boards (PCBs) and populating them with electronic components. It involves the full assembly of a board into a functional circuit board. In board manufacturing, multiple PCBs are grouped on a single panel for efficient processing.
A reflow oven is a machine used primarily for reflow soldering of surface mount electronic components to printed circuit boards (PCBs). In commercial high-volume use, reflow ovens take the form of a long tunnel containing a conveyor belt along which PCBs travel. For prototyping or hobbyist use PCBs can be placed in a small oven with a door.
When potting a circuit board that uses surface-mount technology, low glass transition temperature (T g) potting compounds such as polyurethane or silicone may be used. High T g potting compounds may break solder bonds through solder fatigue by hardening at a higher temperature because the coating then shrinks as a rigid solid over a larger part ...
Sensors installed to a fixture to check selective solder machine parameters Selective soldering machine. Selective soldering is the process of selectively soldering components to printed circuit boards and molded modules that could be damaged by the heat of a reflow oven or wave soldering in a traditional surface-mount technology (SMT) or through-hole technology assembly processes.