Search results
Results from the WOW.Com Content Network
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
Chevrolet (/ ˌ ʃ ɛ v r ə ˈ l eɪ / SHEV-rə-LAY), colloquially referred to as Chevy, is an American automobile division of the manufacturer General Motors (GM).. Louis Chevrolet (1878–1941), Arthur Chevrolet (1884–1946) and ousted General Motors founder William C. Durant (1861–1947) started the company on November 3, 1911 [2] as the Chevrolet Motor Car Company.
The 267 was introduced in 1979 for the GM F-body (Camaro), G-body (Chevrolet Monte Carlo, El Camino), A-body (Malibu Classic, 1979–1981) and also used on GM B-body cars (Impala and Caprice models). The 4.4 L; 267.8 cu in (4,389 cc) engine had the 350's crankshaft stroke of 3.48 in (88.4 mm) and the smallest bore of any small-block, 3.5 in (88 ...
There were other major differences between the Turbo-Thrift engine and the Stovebolt: Bore spacing matches the Chevrolet small-block V8's 4.4 inches,; Stroke of the 194 and 230 engines is the same 3 + 1 ⁄ 4 in (82.6 mm) as the 327 small-block and 348 big-block V8s
GM's Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydramatic introduced in 1940. [1] The Hydramatic was a big success, and had been installed in the majority of GM models by 1950.
The 122 engine was designed by Chevrolet and was used in a wide array of General Motors vehicles. The 122 was similar to the first two generations of the General Motors 60° V6 engine; sharing cylinder bore diameters and some parts. [citation needed] The 122 was available in the U.S. beginning in 1982 for the GM J platform compact cars and S ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.