enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hand drill - Wikipedia

   en.wikipedia.org/wiki/Hand_drill

   A hand drill is the simplest primitive method to produce rapid rotary motion of a rod. It consists in holding the rod vertically between both hands and moving these back and forth, in opposite directions, as in rubbing them. The rod typically is one or two feet long and half an inch in diameter. Hand drills have been used by many primitive ...

3. Brace (tool) - Wikipedia

   en.wikipedia.org/wiki/Brace_(tool)

   A brace is a hand tool used with a bit (drill bit or auger) to drill holes, usually in wood. Pressure is applied to the top while the handle is rotated. If the bit's lead and cutting spurs are both in good working order, the user should not have to apply any pressure other than for balance: the lead will pull the bit through the wood.

4. Gimlet (tool) - Wikipedia

   en.wikipedia.org/wiki/Gimlet_(tool)

   A gimlet is a hand tool for drilling small holes, mainly in wood, without splitting. It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other". [1] A gimlet is always a small tool.

5. Drill - Wikipedia

   en.wikipedia.org/wiki/Drill

   A hand-held corded electric drill A lightweight magnetic-mount drill. A drill is a tool used for making round holes or driving fasteners. It is fitted with a bit, either a drill or driver chuck. Hand-operated types are dramatically decreasing in popularity and cordless battery-powered ones proliferating due to increased efficiency and ease of use.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   An 1/8 inch left-hand drill bit. Left-hand bits are almost always twist bits and are predominantly used in the repetition engineering industry on screw machines or drilling heads. Left-handed drill bits allow a machining operation to continue where either the spindle cannot be reversed or the design of the machine makes it more efficient to run ...

7. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   Chucking reamers, or machine reamers, are the most common type of reamer used in lathes, drill presses, and screw machines that provide a smooth finish to the hole. They come in a variety of flutes and cuts (e.g. right hand cut, left hand spiral, straight flute) as well as different shank types.

8. Bow drill - Wikipedia

   en.wikipedia.org/wiki/Bow_drill

   An image of a wooden bow drill designed for fire starting. The spindle can be held into a fixed frame, or by a hand-held block (the hand piece or thimble) with a hole into which the top of the shaft is inserted. Some lubricant should be used to reduce friction between these two parts, otherwise, it could lead to some trouble when doing it too fast.

9. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.