Search results
Results from the WOW.Com Content Network
ANSI/TIA-568 is a technical standard for commercial building cabling for telecommunications products and services. The title of the standard is Commercial Building Telecommunications Cabling Standard and is published by the Telecommunications Industry Association (TIA), a body accredited by the American National Standards Institute (ANSI).
A cable wired as T568A at one end and wired as T568B at the other end (Tx and Rx pairs reversed) is an Ethernet crossover cable. Before the widespread acceptance of auto MDI-X capabilities, a crossover cable was needed to interconnect similar network equipment (such as Ethernet hubs to Ethernet hubs). Crossover cables are sometimes still used ...
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
Structured cabling network diagram. Structured cabling is the design and installation of a cabling system that will support multiple hardware uses and be suitable for today's needs and those of the future. With a correctly installed system, current and future requirements can be met, and hardware that is added in the future will be supported. [1]
Broadband LAN using Coaxial Cable: Disbanded IEEE 802.8: Fiber Optic TAG: Disbanded IEEE 802.9: Integrated Services LAN (ISLAN or isoEthernet) Disbanded IEEE 802.10: Interoperable LAN Security: Disbanded IEEE 802.11: Wireless LAN (WLAN) & Mesh (Wi-Fi certification) Active IEEE 802.12: 100BaseVG: Disbanded IEEE 802.13: Unused [5] Reserved for ...
The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.
The port numbers in the range from 0 to 1023 (0 to 2 10 − 1) are the well-known ports or system ports. [3] They are used by system processes that provide widely used types of network services.
The cable should be grounded only at one end. Grounding the terminators at both may produce a ground loop and can cause network outages or data corruption when swells of electricity traverse the coaxial cabling's outer shield. When wiring a 10BASE2 network, special care has to be taken to ensure that cables are properly connected to all T ...