Search results
Results from the WOW.Com Content Network
When the output disk is adjusted to a position equal to its own radius, the resulting drive ratio is 1:1. The drive ratio can be set to infinity (i.e. a stationary output disk) by moving the output disk to the center of the input disk. The output direction can also be reversed by moving the output disk past the center of the input disk.
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
The clutch consisted of a wrap-spring clutch-brake that was coupled to the rotor by one or two stages of reduction gearing. The clutch-brake locked up when rotated backwards, but also had some spring action. The inertia of the rotor going backwards engaged the clutch and wound the spring. As it unwound, it restarted the motor in the correct ...
The open belt drive has parallel shafts rotating in the same direction, whereas the cross-belt drive also bears parallel shafts but rotate in opposite direction. The former is far more common, and the latter not appropriate for timing and standard V-belts unless there is a twist between each pulley so that the pulleys only contact the same belt ...
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
The output disks are connected to a gear, coupling, or pulley via drive cup. The clutch slips until the input and output RPMs are matched. This happens relatively quickly typically (0.2 - 2 sec). When the current is removed from the clutch, the armature is free to turn with the shaft.
67P/Churyumov–Gerasimenko (abbreviated as 67P or 67P/C–G) is a Jupiter-family comet. [10] It is originally from the Kuiper belt [11] and has an orbital period of 6.45 years as of 2012, [1] a rotation period of approximately 12.4 hours, [9] and a maximum velocity of 135,000 km/h (38 km/s; 84,000 mph). [12]
The Comet J11 was manufactured from 1954 to 1955. Engine: Villiers Mk 4F (98cc) (47mm x 57mm), Carburetor was a Villiers Type 6/0; Transmission: Two speed with clutch. Frame: Single down tube; Suspension: Front was lightweight telescopic fork, plastic gaiters. Rear was a plunger-type. Brakes: 4" front, 5" rear; Drive: Chain and sprocket