Search results
Results from the WOW.Com Content Network
As another example, a regulation might limit the concentration of particulate matter to 0.1 grain per standard cubic foot (i.e., scf) of dry exhaust gas corrected to 12 volume percent CO 2. Environmental agencies in the USA often denote a standard cubic foot of dry gas as "dscf" or as "scfd".
The standard unit is the meter cubed per kilogram (m 3 /kg or m 3 ·kg −1). Sometimes specific volume is expressed in terms of the number of cubic centimeters occupied by one gram of a substance. In this case, the unit is the centimeter cubed per gram (cm 3 /g or cm 3 ·g −1). To convert m 3 /kg to cm 3 /g, multiply by 1000; conversely ...
An arterial blood gas (ABG) test, or arterial blood gas analysis (ABGA) measures the amounts of arterial gases, such as oxygen and carbon dioxide. An ABG test requires that a small volume of blood be drawn from the radial artery with a syringe and a thin needle , [ 1 ] but sometimes the femoral artery in the groin or another site is used.
= 1000 kg/m 3: kilogram per cubic metre (SI unit) kg/m 3: ≡ kg/m 3 = 1 kg/m 3: kilogram per litre kg/L ≡ kg/L = 1000 kg/m 3: ounce (avoirdupois) per cubic foot oz/ft 3: ≡ oz/ft 3: ≈ 1.001 153 961 kg/m 3: ounce (avoirdupois) per cubic inch oz/in 3: ≡ oz/in 3: ≈ 1.729 994 044 × 10 3 kg/m 3: ounce (avoirdupois) per gallon (imperial ...
Some express the concentrations as ppmv (parts per million by volume) and some express the concentrations as mg/m 3 (milligrams per cubic meter), while others require adjusting or correcting the concentrations to reference conditions of moisture content, oxygen content or carbon dioxide content.
k H CO 2 is a constant including the solubility of carbon dioxide in blood. k H CO 2 is approximately 0.03 (mmol/L)/mmHg; p CO 2 is the partial pressure of carbon dioxide in the blood; Combining these equations results in the following equation relating the pH of blood to the concentration of bicarbonate and the partial pressure of carbon ...
To convert heat values to joules per mole values, multiply by 44.095 g/mol. To convert densities to moles per liter, multiply by 22.678 cm 3 mol/(L·g). Data obtained from CRC Handbook of Chemistry and Physics , 44th ed. pages 2560–2561, except for critical temperature line (31.1 °C) and temperatures −30 °C and below, which are taken from ...
Recall that the relationship represented in a Davenport diagram is a relationship between three variables: P CO 2, bicarbonate concentration and pH.Thus, Fig. 7 can be thought of as a topographical map—that is, a two-dimensional representation of a three-dimensional surface—where each isopleth indicates a different partial pressure or “altitude.”