Search results
Results from the WOW.Com Content Network
2 emissions are measured in pounds per hour using both an SO 2 pollutant concentration monitor and a volumetric flow monitor. For NO x, both a NO x pollutant concentration monitor and a diluent gas monitor are used to determine the emissions rate in weight per volume or weight per heat value (for example lbs/million Btu, lbs/ft 3, kg/kWh or kg ...
The National Emission Standards for Hazardous Air Pollutants (NESHAP) are air pollution standards issued by the United States Environmental Protection Agency (EPA). The standards, authorized by the Clean Air Act, are for pollutants not covered by the National Ambient Air Quality Standards (NAAQS) that may cause an increase in fatalities or in serious, irreversible, or incapacitating illness.
Concentrations in ppm of the major greenhouse gases between 1978 and 2010. Greenhouse gas monitoring is the direct measurement of greenhouse gas emissions and levels. There are several different methods of measuring carbon dioxide concentrations in the atmosphere, including infrared analyzing and manometry.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
ORSAT analyzer. An Orsat gas analyser or Orsat apparatus is a piece of laboratory equipment used to analyse a gas sample (typically fossil fuel flue gas) for its oxygen, carbon monoxide and carbon dioxide content. Although largely replaced by instrumental techniques, the Orsat remains a reliable method of measurement and is relatively simple to ...
An emission inventory (or emissions inventory [1]) is an accounting of the amount of pollutants discharged into the atmosphere.An emission inventory usually contains the total emissions for one or more specific greenhouse gases or air pollutants, originating from all source categories in a certain geographical area and within a specified time span, usually a specific year.
The first published attempt to use plasma emissions as a source for spectroscopic analysis were in 1956 by Eugen Bădărău. [6] In 1964 Stanley Greenfield working at Albright & Wilson was the first to use ICP for non experimental analysis. [6] The first commercial machine was produced by KONTRON in 1975. [6]
A residual gas analyzer (RGA) is a small and usually rugged mass spectrometer, typically designed for process control and contamination monitoring in vacuum systems. When constructed as a quadrupole mass analyzer , there exist two implementations, utilizing either an open ion source (OIS) or a closed ion source (CIS).