enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Punched tape - Wikipedia

   en.wikipedia.org/wiki/Punched_tape

   Tape for punching was usually 0.00394 inches (0.100 mm) thick. The two most common widths were 11 ⁄ 16 inch (17 mm) for five bit codes, and 1 inch (25 mm) for tapes with six or more bits. Hole spacing was 0.1 inches (2.5 mm) in both directions. Data holes were 0.072 inches (1.8 mm) in diameter; sprocket feed holes were 0.046 inches (1.2 mm). [7]

3. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Some 2-hole punches have an "888" marking on their paper guide, to assist punching all four holes into A4 paper. [ 5 ] Konica Minolta specifies that for European 4-hole arrangements, all holes should be 11 ± 1 mm from the nearest (i.e. long/spine) edge of the paper, [ 6 ] which is slightly at variance with ISO 838's specification of 12 ± 1 mm .

4. Wheatstone system - Wikipedia

   en.wikipedia.org/wiki/Wheatstone_system

   The paper punches were labelled with numbers: 1 for the top hole of the dot, 2 for the sprocket hole for dot, and 3 for the bottom hole for dot. When a dash was punched, extra hole punches to the right punched a centre hole with number 4 and a bottom hole with number 5. [2] The perforator was introduced in 1867. [6]

5. Chad (paper) - Wikipedia

   en.wikipedia.org/wiki/Chad_(paper)

   Chad (paper) Chads from punched cards. Each chad is about 3 mm (1⁄8 in) long. Chad refers to fragments sometimes created when holes are made in a paper, card or similar synthetic materials, such as computer punched tape or punched cards. The word "chad" has been used both as a mass noun (as in "a pile of chad") and as a countable noun ...

6. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Punching is a forming process that uses a punch press to force a tool, called a punch, through the workpiece to create a hole via shearing. Punching is applicable to a wide variety of materials that come in sheet form, including sheet metal, paper, vulcanized fibre and some forms of plastic sheet. The punch often passes through the work into a die.