Search results
Results from the WOW.Com Content Network
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
Lossless compression of digitized data such as video, digitized film, and audio preserves all the information, but it does not generally achieve compression ratio much better than 2:1 because of the intrinsic entropy of the data. Compression algorithms which provide higher ratios either incur very large overheads or work only for specific data ...
In aeronautical engineering, overall pressure ratio, or overall compression ratio, is the amount of times the pressure increases due to ram compression and the work done by the compressor stages. The compressor pressure ratio is the ratio of the stagnation pressures at the front and rear of the compressor of a gas turbine .
This formula was derived in 1744 by the Swiss mathematician Leonhard Euler. [2] The column will remain straight for loads less than the critical load. The critical load is the greatest load that will not cause lateral deflection (buckling). For loads greater than the critical load, the column will deflect laterally.
Compression of solids has many implications in materials science, physics and structural engineering, for compression yields noticeable amounts of stress and tension. By inducing compression, mechanical properties such as compressive strength or modulus of elasticity, can be measured. [5]
Compression set B is (like Compression set A) defined as the percentage of specimen deflection after it has been left in normal (uncompressed) conditions for 30 minutes. C B , the compression set B is given by C B = [(t o - t i ) / (t o - t n )] * 100 where t o is the original specimen thickness, t i is the specimen thickness after testing and ...
The net work produced is also represented by the area enclosed by the cycle on the p–V diagram. The net work is produced per cycle and is also called the useful work, as it can be turned to other useful types of energy and propel a vehicle (kinetic energy) or produce electrical energy. The summation of many such cycles per unit of time is ...