Search results
Results from the WOW.Com Content Network
A guide to the recoil from the cartridge, and an indicator of bullet penetration potential. The .30-06 Springfield (at 2.064 lbf-s) is considered the upper limit for tolerable recoil for inexperienced rifle shooters. [2] Chg: Propellant charge, in grains; Dia: Bullet diameter, in inches; BC: Ballistic coefficient, G1 model; L: Case length (mm)
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
.950 JDJ cases are approximately 70 mm in length, and are based on a 20×102mm Vulcan case shortened and necked up to accept the .950 in (24.1 mm) bullet. Projectiles are custom-made and most commonly weigh 3,600 grains (230 g) which is 8.2 ounces or over half a pound.
Handloading is possible with 5.7×28mm ammunition, and 5.7 mm (0.22 in) bullets are widely available due to use in .223 Remington and 5.56×45mm NATO cartridges. [10] Handloaders have noted that the 5.7×28mm cartridge is very sensitive to small changes in powder charge or overall length (OAL) with a bullet inserted. [ 47 ]
For example, the .308 Winchester uses a bullet of 308/1000-inch diameter and was standardized by Winchester. Conversely, cartridge names often reflect nothing related to the cartridge in any obvious way. For example, the .218 Bee uses a bullet of 224/1000-inch diameter, fired through a .22-in bore, etc.
Bullets are generally designed to penetrate, deform, or break apart. For a given material and bullet, the strike velocity is the primary factor that determines which outcome is achieved. Bullet shapes are many and varied. With a mold, bullets can be made at home for reloading ammunition, where local laws allow.
The cost per round of wax bullets is low as primers can be purchased for under US$ 2.00 per 100 in case lots and as the wax itself can be reused. Reloading is very quick, and requires minimal equipment: a decapper tool to knock out the used primer and a priming tool. With these, loading 50 rounds of wax bullets will take under ten minutes.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...