Search results
Results from the WOW.Com Content Network
Top and Front view of a milled undercut slot. In milling the spindle is where a cutting tool is mounted. In some situations material must be cut from a direction where the feature can not be seen from the perspective of the spindle and requires special tooling to reach behind the visible material.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
In machining, the rake angle is a parameter used in various cutting processes, describing the angle of the cutting face relative to the workpiece. There are three types of rake angles: positive, zero or neutral, and negative. Positive rake: A tool has a positive rake when the face of the cutting tool slopes away from the cutting edge at inner side.
Material removal rate (MRR) is the amount of material removed per time unit (usually per minute) when performing machining operations such as using a lathe or milling machine. The more material removed per minute, the higher the material removal rate. [1] [2] The MRR is a single number that enables you to do this. It is a direct indicator of ...
They are often used at the end of the threaded portion of a shaft or screw to provide clearance for the cutting tool, and also referred to as thread relief in this context. A rule of thumb is that the undercut should be at least 1.5 threads long and the diameter should be at least 0.015 in (0.38 mm) smaller than the minor diameter of the thread ...
SFM is a combination of diameter and the velocity of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.
Printable version; In other projects ... are dependent on depth of cut, ... and Hassan El-Hofy CRC Press 2008 Pages 371–390 Print ISBN 978-1-4200-4339-6 ...
Center gauges and fishtail gauges [1] are gauges used in lathe work for checking the angles when grinding the profiles of single-point screw-cutting tool bits and centers. In the image, the gauge on the left is called a fishtail gauge or center gauge, and the one on the right is another style of center gauge. [2]