Search results
Results from the WOW.Com Content Network
In aeronautics, the rate of climb (RoC) is an aircraft's vertical speed, that is the positive or negative rate of altitude change with respect to time. [1] In most ICAO member countries, even in otherwise metric countries, this is usually expressed in feet per minute (ft/min); elsewhere, it is commonly expressed in metres per second (m/s).
The rate of climb measurement comes from the rate-of-air inflow or outflow from the container." [4] Variometers measure the rate of change of altitude by detecting the change in air pressure (static pressure) as altitude changes. Common types of variometers include those based on a diaphragm, a vane (horn), a taut band, or are electric based.
Indicated airspeed is a better measure of power required and lift available than true airspeed. Therefore, IAS is used for controlling the aircraft during taxiing, takeoff, climb, descent, approach or landing. Target speeds for best rate of climb, best range, and best endurance are given in terms of indicated speed.
The computer is connected to sensors that detect the aircraft's airspeed and rate of sink. If linked to a GPS, and using a computed or manual estimate of the windspeed, the glide computer can also calculate the speed and altitude necessary to glide to a particular destination. This glide is known as the final glide because no further lift ...
An airspeed indicator for an aeroplane. Indicated airspeed is displayed on the black background (in this case both in knots (kn) and miles per hour (mph)). The pilot sets the pressure altitude and air temperature in the top window using the knob. Based on that, the white background scale in the lower left window moves to give true airspeed.
It works by measuring pressures or pressure differences and using these values to assess the speed and altitude. [1] These pressures can be measured either from the static port (static pressure) or the pitot tube (pitot pressure). The static pressure is used in all measurements, while the pitot pressure is used only to determine airspeed.
It is one measure of how strongly an aircraft wants to fly "nose first", which is clearly very important. Stability derivatives, and also control derivatives, are measures of how particular forces and moments on an aircraft change as other parameters related to stability change (parameters such as airspeed, altitude, angle of attack, etc.). For ...
The rate of change of aircraft mass with distance is = =, where is the speed), so that = It follows that the range is obtained from the definite integral below, with t 1 {\displaystyle t_{1}} and t 2 {\displaystyle t_{2}} the start and finish times respectively and W 1 {\displaystyle W_{1}} and W 2 {\displaystyle W_{2}} the initial and final ...