Search results
Results from the WOW.Com Content Network
A segment can be extended by allocating another memory page and adding it to the segment's page table. An implementation of virtual memory on a system using segmentation with paging usually only moves individual pages back and forth between main memory and secondary storage, similar to a paged non-segmented system. Pages of the segment can be ...
Without paging support the segment is the physical unit swapped in and out of memory if required. With paging support the pages are usually the unit of swapping and segmentation only adds an additional level of security. Addresses in a segmented system usually consist of the segment id and an offset relative to the segment base address, defined ...
Overlays are not a method of paging RAM to disk but merely of minimizing the program's RAM use. Subsequent architectures used memory segmentation, and individual program segments became the units exchanged between disk and RAM. A segment was the program's entire code segment or data segment, or sometimes other large data structures.
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.
This will typically occur because of a programming error, and the operating system must take some action to deal with the problem. On modern operating systems, it will cause a segmentation fault signal being sent to the offending program. The lookup may also fail if the page is currently not resident in physical memory.
Flat memory model or linear memory model refers to a memory addressing paradigm in which "memory appears to the program as a single contiguous address space." [1] The CPU can directly (and linearly) address all of the available memory locations without having to resort to any sort of bank switching, memory segmentation or paging schemes.
The 80286 added an MMU that supports segmentation, but not paging. When segmentation is enabled by turning on protected mode, the segment number acts as an index into a table of segment descriptors; a segment descriptor contains a base physical address, a segment length, a presence bit to indicate whether the segment is currently in memory ...
The term "segment" comes from the memory segment, which is a historical approach to memory management that has been succeeded by paging.When a program is stored in an object file, the code segment is a part of this file; when the loader places a program into memory so that it may be executed, various memory regions are allocated (in particular, as pages), corresponding to both the segments in ...