enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rod end bearing - Wikipedia

   en.wikipedia.org/wiki/Rod_end_bearing

   A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

3. Moog Inc. - Wikipedia

   en.wikipedia.org/wiki/Moog_Inc.

   Moog Inc. (/ m oʊ ɡ / MOHG) is an American-based designer and manufacturer of electric, electro-hydraulic and hydraulic motion, controls and systems for applications in aerospace, defense, industrial and medical devices. The company operates under four segments: aircraft controls, space and defense controls, industrial controls, and components.

4. Tie rod - Wikipedia

   en.wikipedia.org/wiki/Tie_rod

   A tie rod or tie bar (also known as a hanger rod if vertical) is a slender structural unit used as a tie and (in most applications) capable of carrying tensile loads only. It is any rod or bar-shaped structural member designed to prevent the separation of two parts, as in a vehicle. Tie rods and anchor plates in the ruins of Coventry Cathedral

5. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...

6. List of moments of inertia - Wikipedia

   en.wikipedia.org/wiki/List_of_moments_of_inertia

   This expression assumes that the rod is an infinitely thin (but rigid) wire. This is a special case of the thin rectangular plate with axis of rotation at the center of the plate, with w = L and h = 0. Thin rod of length L and mass m, perpendicular to the axis of rotation, rotating about one end.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.