Search results
Results from the WOW.Com Content Network
Supercritical airfoils feature four main benefits: they have a higher drag-divergence Mach number, [21] they develop shock waves farther aft than traditional airfoils, [22] they greatly reduce shock-induced boundary layer separation, and their geometry allows more efficient wing design (e.g., a thicker wing and/or reduced wing sweep, each of which may allow a lighter wing).
After World War II, NACA research began to focus on near-sonic and low-supersonic airflow.After considering the sudden drag increase which a wing-fuselage combination experiences at somewhere around 500 mph (800 km/h), Whitcomb concluded that "the disturbances and shock waves are simply a function of the longitudinal variation of the cross-sectional area" – that is, the effect of the wings ...
Thin supercritical wing section and swept-back wing can postpone shock stall to higher speed. [1] A stall is the decrease in lift to a value below the weight, and the associated increase in drag upon the separation of the boundary layer (in this case behind the shock wave).
Years of research and experience with the unusual conditions of supersonic flow have led to some interesting conclusions about airfoil design. Considering a rectangular wing, the pressure at a point P with coordinates (x,y) on the wing is defined only by the pressure disturbances originated at points within the upstream Mach cone emanating from point P. [3] As result, the wing tips modify the ...
Payoff chart from buying a butterfly spread. Profit from a long butterfly spread position. The spread is created by buying a call with a relatively low strike (x 1), buying a call with a relatively high strike (x 3), and shorting two calls with a strike in between (x 2).
The supercritical airfoil is a type that results in reasonable low speed lift like a normal airfoil, but has a profile considerably closer to that of the von Kármán ogive. All modern civil airliners use forms of supercritical aerofoil and have substantial supersonic flow over the wing upper surface.
The natural outcome of this requirement is a wing design that is thin and wide, which has a low thickness-to-chord ratio. At lower speeds, undesirable parasitic drag is largely a function of the total surface area, which suggests using a wing with minimum chord, leading to the high aspect ratios seen on light aircraft and regional airliners ...
Experimental Vought F-8 Crusader with supercritical wing. The supercritical wing would have been prone to pitch-up as the wing had increased sweep and aspect ratio compared to the standard wing. No pitch-up problems were experienced with vortilons fitted. [14] [15] Bombardier Challenger 300, later becoming the Challenger 350 & new 3500 series.