Search results
Results from the WOW.Com Content Network
Rock Chuck Bullet Swage (later abbreviated RCBS) is a handloading equipment manufacturer operating in Oroville, California. The company originated during the sporting ammunition shortage caused by World War II , became a widely recognized manufacturer of handloading equipment, and has subsequently been purchased by Hodgdon Powder Company .
Adopted in 1912, the 9mm Steyr was the service ammunition for most branches of the military in Austria-Hungary during World War I and remained the service ammunition for Austria, Romania and Chile between the World Wars. [2] Some MP 34 submachine guns were also issued in this caliber in addition to 9×25mm Mauser.
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
Making the 9×25mm Dillon is fairly easy. Dillon Precision makes the necessary resizing die, and reliable reloading data is easily found. Most people use 115- to 125-grain bullets, but bullets with weights as low as 80 grains are used, too.
This is a list of firearm cartridges that have bullets in the 9 millimeters (0.35 in) to 9.99 millimeters (0.393 in) caliber range. Case length refers to the round case length. OAL refers to the overall length of the loaded round.
However, there are multiple companies worldwide who make 9.3mm (.366") Mauser bullets which are suitable for reloading in the 9×39, including Hornady, Barnes, Nosler, Prvi Partizan, Lapua, and others. Redding Reloading produces a set of full size reloading dies.
The cylinder is bored straight through with no step. Later versions used an inside the case lubricated bullet of .357" diameter instead of the original .38" with a reduction in bore diameter. The difference in .38 Special bullet diameter and case diameter reflects the thickness of the case mouth (approximately 11/1000-inch per side).
The defined distance for a particular chambering is published in the TDCC data sheet of the chambering. In a rifle cartridge case like the .308 Winchester , the TDCC M = 25.00 value denotes the transducer must be positioned at a distance of 25 millimetres (0.98 in) from the breech face.