enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Condensate pump - Wikipedia

   en.wikipedia.org/wiki/Condensate_pump

   The output of small condensate pumps is usually routed to a sewer, plumbing drain, or the outside world via PVC plastic tubing (condensate drain line). In some locales, condensate water is not permitted to enter a sewer system and must be directed to the outside of the house, usually into the leader/gutter downspout system, or the stormwater ...

3. Dehumidifier - Wikipedia

   en.wikipedia.org/wiki/Dehumidifier

   The condensate should not be directed into a septic system of a house, because it does not need special treatment as effluent. When the height of the air handler (containing the evaporator) is above the level of the surface drains used for rainwater, the condensate drain lines can often be routed into them. Air handlers located below grade ...

4. Pan evaporation - Wikipedia

   en.wikipedia.org/wiki/Pan_evaporation

   The sunken Colorado pan is square, 0.92 m (3 ft) on a side and 0.46 m (18 in.) deep and made of unpainted galvanized iron. As the name suggests, it is buried in the ground to within about 5 cm (2 in.) of its rim. Evaporation from a Sunken Colorado Pan can be compared with a Class A pan using conversion constants.

5. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   Dehumidification (air drying) in an air conditioning system is provided by the evaporator. Since the evaporator operates at a temperature below the dew point, moisture in the air condenses on the evaporator coil tubes. This moisture is collected at the bottom of the evaporator in a pan and removed by piping to a central drain or onto the ground ...

6. Condenser (heat transfer) - Wikipedia

   en.wikipedia.org/wiki/Condenser_(heat_transfer)

   The condensate drips down and collects at the bottom, often in a built-in pan called a hotwell. The shell side often operates at a vacuum or partial vacuum, produced by the difference in specific volume between the steam and condensate. Conversely, the vapor can be fed through the tubes with the coolant water or air flowing around the outside.

7. Vapor-compression evaporation - Wikipedia

   en.wikipedia.org/wiki/Vapor-compression_evaporation

   The compression ratio in a MVR unit does not usually exceed 1.8. At a compression ratio of 1.8, if the evaporation is performed at atmospheric pressure (0.101 MPa), the condensation pressure after compression will be 0.101 x 1.8 = 0.1818 [MPa]. At this pressure, the condensation temperature of the water vapor at the heat exchanger will be 390 K.