Ad
related to: ethernet cable detector for computer monitor
Search results
Results from the WOW.Com Content Network
A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.
An attempt by Apple to deal with cable clutter, by combining five separate cables from computer to monitor. Female port (20-pin) Digital Flat Panel (DFP) Used with the PanelLink digital video protocol. Deprecated. Made obsolete by DVI. 3D model of a UDI connector Unified Display Interface: Proposed to replace both DVI and HDMI.
A network tap is a system that monitors events on a local network. A tap is typically a dedicated hardware device, which provides a way to access the data flowing across a computer network. The network tap has (at least) three ports: an A port, a B port, and a monitor port. A tap inserted between A and B passes all traffic (send and receive ...
On original 10BASE5 (thicknet) Ethernet equipment, the MAU was typically clamped to the Ethernet wire via a vampire tap and connected by a multi-wire cable to the computer via a DA-15 port, which was also present on the network interface controller (NIC). This AUI cable could be up to 50 metres (160 ft) long, but was typically much shorter.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
ZVA40 vector network analyzer from Rohde & Schwarz.. A network analyzer is an instrument that measures the network parameters of electrical networks.Today, network analyzers commonly measure s–parameters because reflection and transmission of electrical networks are easy to measure at high frequencies, but there are other network parameter sets such as y-parameters, z-parameters, and h ...
A vampire tap (also called a piercing tap) is a device for physically connecting a station, typically a computer, to a network that used 10BASE5 cabling. This device clamped onto and "bit" into the cable [ 1 ] (hence the name " vampire "), inserting a probe through a hole drilled using a special tool through the outer shielding to contact the ...
Ad
related to: ethernet cable detector for computer monitor