Search results
Results from the WOW.Com Content Network
CSMA/CD was used in now-obsolete shared-medium Ethernet variants (10BASE5, 10BASE2), and in the early versions of twisted-pair Ethernet, which used repeater hubs. Modern Ethernet networks, built with switches and full-duplex connections, no longer need to use CSMA/CD, because each Ethernet segment, or collision domain, is now isolated. CSMA/CD ...
A medium-dependent interface (MDI) describes the interface (both physical and electrical/optical) in a computer network from a physical-layer implementation to the physical medium used to carry the transmission. Ethernet over twisted pair also defines a medium-dependent interface – crossover (MDI-X) interface.
An Ethernet adapter card for the IBM PC was released in 1982, and, by 1985, 3Com had sold 100,000. [16] In the 1980s, IBM's own PC Network product competed with Ethernet for the PC, and through the 1980s, LAN hardware, in general, was not common on PCs. However, in the mid to late 1980s, PC networking did become popular in offices and schools ...
On original 10BASE5 (thicknet) Ethernet equipment, the MAU was typically clamped to the Ethernet wire via a vampire tap and connected by a multi-wire cable to the computer via a DA-15 port, which was also present on the network interface controller (NIC). This AUI cable could be up to 50 metres (160 ft) long, but was typically much shorter.
A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.
A vampire tap (also called a piercing tap) is a device for physically connecting a station, typically a computer, to a network that used 10BASE5 cabling. This device clamped onto and "bit" into the cable [ 1 ] (hence the name " vampire "), inserting a probe through a hole drilled using a special tool through the outer shielding to contact the ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...