Search results
Results from the WOW.Com Content Network
Turboshaft engines (9 C, 6 P) Pages in category "Helicopter components" The following 22 pages are in this category, out of 22 total.
The Bell 204 and 205 are the civilian versions of the UH-1 Iroquois single-engine military helicopter of the Huey family of helicopters. They are type-certificated in the transport category and are used in a wide variety of applications, including crop dusting, cargo lifting, Forestry Operations, and aerial firefighting.
Parachute Riggers/Packers in training attend the 15-day Basic Parachute qualification course at CFB Trenton, and then for approximately 2.5–3 years undertake three different 45-day courses that cover maintaining parachutes, packing parachutes, and quality control of parachutes.
The helicopter crew chief can be seen in the floor hatch providing assistance. Improperly rigged cargo loads can threaten the aircraft as well as people on the ground. External loads must be prepared and inspected by trained personnel, and all rigging equipment must be rated for the weight of the load and in servicable condition.
Abrasion strips on helicopter rotor blades are made of metal, often titanium or nickel, which are very hard, but less hard than sand. When a helicopter flies low to the ground in desert environments, sand striking the rotor blade can cause erosion. At night, sand hitting the metal abrasion strip causes a visible corona or halo around the rotor ...
Location of flight controls in a helicopter. Helicopter flight controls are used to achieve and maintain controlled aerodynamic helicopter flight. [1] Changes to the aircraft flight control system transmit mechanically to the rotor, producing aerodynamic effects on the rotor blades that make the helicopter move in a desired way.
1. Non-rotating outer ring (blue). 2. Turning inner ring (silver). 3. Ball joint. 4. Control (pitch) preventing turning of outer ring. 5. Control (roll). 6. Linkages (silver) to the rotor blade. In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades.
Doblhoff WNF 342 V4 model. During the Second World War, German engineer Friedrich von Doblhoff suggested powering a helicopter with ramjets located on the rotor tips. His idea was taken forwards and, during 1943, the WNF 342 V1 became the first tip jet-powered helicopter; it used a conventional piston engine to drive both a compact propeller and an air compressor to provide air (subsequently ...