Search results
Results from the WOW.Com Content Network
-Instead of the more complex high speed test tones generator, Capitol Records Canada, designed a real time test tone generator and recorded these tones onto the one inch master along with the music.-This not only reduced design time but also allowed Capitol Records Canada to test the entire chain from the master tape to the final cassette tape.
The last section consists of 2 kHz tone at -24dBFS on all six channels. This can be used to check phase between any of the 5.1 legs. When the tone is summed to stereo using default down-mix values this section should produce tones of approximately -18 dBfs on each channel. The BLITS sequence repeats approximately every 14 seconds.
Two-tone receiver testing using direct injection [8] Two-tone receiver testing using off-air method [9] A test setup suitable for testing receivers at microwave frequencies is shown in the figure. The two signal generators, F1 and F2, are combined using a directional coupler in reverse.
NPA+102 – Plant Test – Milliwatt tone (1004 Hz) NPA+103 – Plant Test – Signaling test termination; NPA+104 – Plant Test – 2-way transmission and noise test; NPA+105 – Plant Test – Automatic Transmission Measuring System; NPA+106 – Plant Test – CCSA loop transmission test; NPA+107 – Plant Test – Par meter generator
Graham's Line Identification Tone System (GLITS) is a test signal for stereo systems devised by BBC TV Sound Supervisor and Fellow of the IPS Graham Haines in the mid-1980s. It comprises a 1 kHz tone at 0 dBu (-18 dBFS ) on both channels, with interruptions which identify the channels.
In telecommunication, a standard test tone is a pure tone with a standardized level generally used for level alignment of single links and of links in tandem. [1]For standardized test signal levels and frequencies, see MIL-STD-188-100 for United States Department of Defense (DOD) use, and the Code of Federal Regulations Title 47, part 68 for other Government agencies.
The PTX8 has mixed stereo L/R outputs and 8 individual outputs (one per Tone Generator). When none of the individual outputs are being used, tone generators are panned across the stereo output. Tone generators 3 & 4 are panned left, 1, 2, 7, & 8 are panned center; 5 & 6 are panned right.
From 1 March 1975, the Dutch public broadcasting system also started to use the Philips circle pattern on its TV channels, replacing the monochrome RMA 1946 Resolution Chart, the electronic monochrome chequerboard test card generated by a Philips GM 2671/50 video signal generator, [141] the Philips PM5552 early colour test card, and after the ...