Search results
Results from the WOW.Com Content Network
Small connectors used on some laptops and other systems in place of the standard VGA connector. microcode A layer of hardware-level instructions involved in the implementation of higher level machine code instructions in many computers and other processors. modem A device that enables two distant computer systems to communicate with one another.
Generally, two connectors, designated male and female, plug together to form a connection which allows two components, such as a computer and a disk drive, to communicate with each other. SCSI connectors can be electrical connectors or optical connectors. There have been a large variety of SCSI connectors in use at one time or another in the ...
The shapes and properties of the electrical connectors, the frequencies to transmit on, the line code to use and similar low-level parameters, are specified by the physical layer. At the electrical layer, the physical layer is commonly implemented by dedicated PHY chip or, in electronic design automation (EDA), by a design block .
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
Major components on a PICMG 1.3 active backplane Wire-wrapped backplane from a 1960s PDP-8 minicomputer. A backplane or backplane system is a group of electrical connectors in parallel with each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus.
Small Computer System Interface (SCSI, / ˈ s k ʌ z i / SKUZ-ee) [2] is a set of standards for physically connecting and transferring data between computers and peripheral devices, best known for its use with storage devices such as hard disk drives.
IC with complex circuits require multiple levels of interconnect to form circuits that have minimal area. As of 2018, the most complex ICs may have over 15 layers of interconnect. Each level of interconnect is separated from each other by a layer of dielectric. To make vertical connections between interconnects on different levels, vias are used.
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.