Search results
Results from the WOW.Com Content Network
In September 1971 the H2 was a direct result of the success of the 500 cc Kawasaki H1 Mach III introduced in 1969. The H2 engine was a 3-cylinder two-stroke with an engine displacement of 748 cc (45.6 cubic inches) which produced 74 horsepower (55 kW) at 6,800 rpm, a power-to-weight ratio of 1 hp (0.75 kW) to every 5.7 lb (2.6 kg) of weight.
The Kawasaki triples were a range of 250 to 750 cc (15 to 46 cu in) motorcycles made by Kawasaki from 1968 to 1980. The engines were air-cooled, three-cylinder, piston-controlled inlet port two-strokes with two exhaust pipes exiting on the right side of the bike, and one on the left.
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
Kawasaki selected the literbike platform for its top-of-the-line Ninja H2 model, rather than continuing with the higher-displacement Ninja ZX-14 hyperbike. Cycle World's Kevin Cameron explained that the literbike class is "the center of the high-performance market", attracting the best development in racing, with the best chassis and suspension design, so it made sense for Kawasaki to create a ...
A process flow diagram (PFD) is a diagram commonly used in chemical and process engineering to indicate the general flow of plant processes and equipment. The PFD displays the relationship between major equipment of a plant facility and does not show minor details such as piping details and designations.
List of motorcycles by type of engine is a list of motorcycles by the type of motorcycle engine used by the vehicle, such as by the number of cylinders or configuration. A transverse engine is an engine mounted in a vehicle so that the engine's crankshaft axis is perpendicular to the direction of travel.
Hydraulic pipe is used in case standard hydraulic tubes are not available. Generally these are used for low pressure. They can be connected by threaded connections, but usually by welds. Because of the larger diameters the pipe can usually be inspected internally after welding. Black pipe is non-galvanized and suitable for welding.
Process piping and power piping are typically checked by pipe stress engineers to verify that the routing, nozzle loads, hangers, and supports are properly placed and selected such that allowable pipe stress is not exceeded under different loads such as sustained loads, operating loads, pressure testing loads, etc., as stipulated by the ASME B31, EN 13480, GOST 32388, RD 10-249 or any other ...