Ads
related to: homemade atv shock spring compressor tssc02 diagram parts list
Search results
Results from the WOW.Com Content Network
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
Pneumatic and hydraulic shock absorbers are used in conjunction with cushions and springs. An automobile shock absorber contains spring-loaded check valves and orifices to control the flow of oil through an internal piston (see below). [1] One design consideration, when designing or choosing a shock absorber, is where that energy will go.
A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever, the torsion key, mounted perpendicular to the bar, that is attached to a ...
Upper purple: Coil spring Yellow: Tubular housing containing shock absorber or damper Lower green: Vehicle frame or unibody member. The MacPherson strut is a type of automotive suspension system that uses the top of a telescopic damper as the upper steering pivot. It is widely used in the front suspension of modern vehicles.
The moving parts of the system, e.g., suspension strut or steering ram, are sealed by contact seals between the cylinder and piston for tightness under pressure. The other plastic/rubber parts are return tubes from valves such as the brake control or height corrector valves, also catching seeping fluid around the suspension push-rods.
Air springs, also called "air helper springs," are placed on existing suspension components on the rear or front of the vehicle in order to increase the load capacity. One of the advantages of using air suspension as a load support enhancement is the air springs can be deflated when not towing or hauling and therefore maintaining the factory ...
WP rear shock unit on a KTM 950 Adventure in 2007. WP Suspension GmbH is a manufacturer of components for motorcycle suspension systems based in Austria. The company was founded in 1977 by Wim Peters in Malden, Netherlands [1] and is amongst the largest manufacturers of suspension components for motorcycles. [2]
This put him in contact with designers of suspension systems for motorcycles and other motocross industry people. Simons is a former motocross rider in his teens and early twenties and entrepreneur. He developed heat sinks for Koni shock absorbers to lower oil temperatures and then in 1974 he designed a shock absorber for the company that ...
Ads
related to: homemade atv shock spring compressor tssc02 diagram parts list