Search results
Results from the WOW.Com Content Network
Turnouts facing and trailing. Note that this diagram is for left-hand traffic; for right-hand traffic, "F" and "T" would be swapped. Facing or trailing are railway turnouts (or 'points' in the UK) in respect to whether they are divergent or convergent. When a train traverses a turnout in a facing direction, it may diverge onto either of the two ...
A right-hand railroad switch with point indicator pointing to right Animated diagram of a right-hand railroad switch. Rail track A divides into two: track B (the straight track) and track C (the diverging track); note that the green line represents direction of travel only, the black lines represent fixed portions of track, and the red lines depict the moving components.
In the example layout shown, trains take the left-hand track in their direction of running. Low-speed turnouts restrict the speed in one direction. Two platform faces are needed, and they can be provided either at a single island platform or two side platforms (as shown). Overtaking is not normally possible at this kind of up-and-down loop as ...
Double junction, or level junction (left hand running). A double junction is a railway junction where a double-track railway splits into two double track lines. Usually, one line is the main line and carries traffic through the junction at normal speed, while the other track is a branch line that carries traffic through the junction at reduced speed.
In any given country, rail traffic generally runs to one side of a double-track line, not always the same side as road traffic. Thus in Belgium, China, France (apart from the classic lines of the former German Alsace and Lorraine), Sweden (apart from Malmö and further south), Switzerland, Italy and Portugal for example, the railways use left-hand running, while the roads use right-hand running.
Double trap points are a full turnout, leading to two tongues. Usually the tongue nearer the main line is longer than the other. Trap points with a crossing are double trap points where the tongues of rail are longer, so that the trap point rail nearest the main line continues over the siding rail with a common crossing or frog.
Three-rail dual-gauge track is joined by four-rail triple-gauge. [k] 1600 / 1435 / 1067mm (5 ft 3 / 4 ft 8 1 / 2 in / 3 ft 6 in). Standard-gauge car on 4-rail triple-gauge track. Narrow gauge track is two central rails; broad gauge is far left rail and second from right. [l] 1600 / 1435 / 1067 mm (5 ft 3 / 4 ft 8 1 / 2 / 3 ft 6 in).
Consider a railway with two block sections as in the diagram. Section 1 has frequency A injected at the left-hand end and received at the right-hand end. Section 2 continues from the right hand end of section 1 where frequency B is injected and then received at the right-hand end of section 2. Track circuited railway with two block sections