Search results
Results from the WOW.Com Content Network
Trachtenberg defined this algorithm with a kind of pairwise multiplication where two digits are multiplied by one digit, essentially only keeping the middle digit of the result. By performing the above algorithm with this pairwise multiplication, even fewer temporary results need to be held. Example:
That is, if CEP is n metres, 50% of shots land within n metres of the mean impact, 43.7% between n and 2n, and 6.1% between 2n and 3n metres, and the proportion of shots that land farther than three times the CEP from the mean is only 0.2%. CEP is not a good measure of accuracy when this distribution behavior is not met.
Mildot chart as used by snipers. Angle can be used for either calculating target size or range if one of them is known. Where the range is known the angle will give the size, where the size is known then the range is given. When out in the field angle can be measured approximately by using calibrated optics or roughly using one's fingers and hands.
As the definition of the unit contains π, it is easy to calculate area values in circular mils when the diameter in mils is known. The area in circular mils, A , of a circle with a diameter of d mils, is given by the formula: { A } c m i l = { d } m i l 2 . {\displaystyle \{A\}_{\mathrm {cmil} }=\{d\}_{\mathrm {mil} }^{2}.}
This is the "grid" or "boxes" structure which gives the multiplication method its name. Faced with a slightly larger multiplication, such as 34 × 13, pupils may initially be encouraged to also break this into tens. So, expanding 34 as 10 + 10 + 10 + 4 and 13 as 10 + 3, the product 34 × 13 might be represented:
Another example is the generation of higher-phase-order systems for large rectifier systems, to produce a smoother DC output and to reduce the harmonic currents in the supply. When three-phase is needed but only single-phase is readily available from the electricity supplier, a phase converter can be used to generate three-phase power from the ...
Continuous charge distribution. The volume charge density ρ is the amount of charge per unit volume (cube), surface charge density σ is amount per unit surface area (circle) with outward unit normal nĚ‚, d is the dipole moment between two point charges, the volume density of these is the polarization density P.
The GEH formula is useful in situations such as the following: [4] [5] [6] Comparing a set of traffic volumes from manual traffic counts with a set of volumes done at the same locations using automation (e.g. a pneumatic tube traffic counter is used to check the total entering volumes at an intersection to affirm the work done by technicians doing a manual count of the turn volumes).