Search results
Results from the WOW.Com Content Network
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
In this example the lookouts are covered when the soffit is finished, as can be seen on the right hand side of the image. A lookout , [ 1 ] lookout rafter or roof outlooker [ 2 ] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface ...
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
Pyramid roof: A steep hip roof on a square building. Pyatthat: A multi-tiered and spired roof commonly found in Burmese royal and Buddhist architecture. Tented: A type of polygonal hipped roof with steeply pitched slopes rising to a peak; Helm roof, Rhenish helm: A pyramidal roof with gable ends; often found on church towers.
The Tomlinson Lumber Co sold pre-cut materials for a 34 by 50 feet (10 m × 15 m) dairy barn with a Gothic-arched roof supported by three-ply rafters in 1958 throughout Minnesota. [ 10 ] The first published plans by an architect for a Gothic-arch barn appeared in 1916.
The reciprocal frame, also known as a Mandala roof, [1] has been used since the twelfth century in Chinese and Japanese architecture although little or no trace of these ancient methods remain. More recently they were used by architects Kazuhiro Ishii (the Spinning House) and Yasufumi Kijima, and engineer Yoishi Kan (Kijima Stonemason Museum).
A roof being framed in the United States circa 1955. Modern timber roofs are mostly framed with pairs of common rafters or prefabricated wooden trusses fastened together with truss connector plates. Timber framed and historic buildings may be framed with principal rafters or timber roof trusses.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.