Ads
related to: suspension split knuckle spreader plate mount conversionsummitracing.com has been visited by 100K+ users in the past month
roughcountry.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
In a drive suspension, the knuckle has no spindle, but rather has a hub into which is affixed the bearings and shaft of the drive mechanism. The end of the drive mechanism would then have the necessary mounting studs for the wheel/tire and/or brake assembly. Therefore, the wheel assembly would rotate as the drive shaft (or half-shaft) dictates.
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
RevoKnuckle is a variation of the MacPherson strut suspension design by Ford which separates steering and suspension movements to provide lower scrub radius [1] and kingpin offset than traditional MacPherson struts.
A simple MacPherson strut suspension on the left front wheel of a rear-wheel drive vehicle. The front of the vehicle is at bottom right of the image. Upper green: Vehicle body/strut interface Red: Steering knuckle or hub carrier Blue: Lower control arm or track control arm Light blue: Steering gear tie rod or track rod Lower purple: Radius rod
The inner fulcrum mounting is adjacent to the bottom of the differential casing. Wide spacing of the pivot bearings provides both torsional and fore-and-aft rigidity to the hub carrier. This prevents the hub carrier from twisting relative to the differential and is also necessary because, with driveshafts acting as the upper suspension links ...
Ads
related to: suspension split knuckle spreader plate mount conversionsummitracing.com has been visited by 100K+ users in the past month
roughcountry.com has been visited by 10K+ users in the past month